Orion-instruments Jupiter 2xx FOUNDATION Fieldbus Manuel d'utilisateur télécharger pdf (Page 9)

57-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™

2.3.3 Operational Considerations

Exterior ambient temperature of the service should not

exceed the design specifications of the electronics (-40° to

+175° F (-40° to +80° C)). The operating temperature

limits of the LCD are -5° to +160° F (-20° to +70° C).

Temperatures below -5° F will cause the display to tem-

porarily white out, and temperatures above +160° F will

cause the display to go temporarily black. It will recover

without damage when the operating temperature range

returns. A sunshade should be used if electronics are

mounted in direct sunlight.

Maximum process temperature for direct insertion

transmitters is +500° F (+260° C). Externally mounted

transmitters can be used with process temperatures up

to +800° F (+427° C) if the MLI is equipped with an

insulation blanket from the factory.

2.3.4 Configuration Information

Some key information is needed to configure the Jupiter

transmitter. Complete the following operating parameters

table before beginning configuration.

Display Question Answer

Units What units of measurement will be

used? (inches or centimeters) _____________

Probe What probe length is listed on the

Length model information? _____________

Measurement Choose from Level Only or

Type Level and Interface _____________

Sensor Choose from MLI Top, MLI Bottom,

Mount Direct Insertion Near (NPT, BSP, and

600# or less flanges) or

Direct Insertion Extended (Flanged

probes 900# class and over) _____________

2.4 Mounting

2.4.1 External

Caution: Do not rotate the Jupiter electronics enclosure. Rotating

the electronics enclosure could cause damage to sensor

cables.

If ordered from the factory with the MLI, it will be

attached to the gauge and configured for the measuring

range specified at the time of order placement. If not, use

the following directions:

1. Place the Jupiter transmitter and mounting clamps in a

convenient location.

Figure 1

Mounting External Jupiter

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Orion-instruments Jupiter 2xx FOUNDATION Fieldbus Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Orion-instruments Jupiter 2xx FOUNDATION Fieldbus